一、產品簡介：

結構膠粘劑T沖擊剝離長度測定儀符合結構膠粘劑T沖擊剝離長度測定方法及評定標準。采用自由落體式?jīng)_擊剝離試驗裝置，適用于室溫固化結構膠粘劑韌性重要標志——T沖擊剝離長度的測定。同時也適用于抗震設防區建筑加固所使用結構膠粘劑的韌性要求，可按本標準進行測試與合格評定。

product introduction:

The structural adhesive T impact peeling length measuring instrument conforms to the measuring method and evaluation standard of structural adhesive T impact peeling length. The free fall type impact peeling test device is suitable for the determination of the T impact peeling length of the room temperature curing structural adhesive. It is also applicable to the toughness requirements of structural adhesives used in building reinforcement in seismic fortification areas. It can be tested and qualified according to this standard.

二、原理：

以一對軟鋼薄片膠接成T沖擊剝離試樣，在規定的條件下，對試樣未膠接端施加沖擊力，使試樣沿其膠接線產生剝離。韌性不同的結構膠粘劑，其剝離長度有顯著差別，從中可判別出其韌性的優劣。

通過測量試樣剝離長度以及對不同型號膠粘劑測試數據的比較分析，可制定出以剝離長度為指標的、簡易、實用的結構膠粘劑韌性合格評定標準。

Second, the principle

1. A pair of mild steel sheets are glued into a T-impact stripping sample, and under the specified conditions, an impact force is applied to the unbonded end of the sample to cause the sample to peel off along the glue line. Structural adhesives with different toughness have significant differences in peel length, from which the toughness can be judged.

2. By measuring the peel length of the sample and comparing and analyzing the test data of different types of adhesives, a simple and practical structural adhesive toughness conformity assessment standard with the peel length as the index can be developed.

三、技術參數：

導桿：20mm

園鋼桿22mm

沖擊塊:900g

鋼桿長度：305mm

重量：25KG

Third, technical parameters

1. Guide rod: 20mm

2, garden steel rod 22mm

3. Impact block: 900g

4, steel rod length: 305mm

5, weight: 25KG